Record Details

Application Of High Frequency Natural Resonances Extracted From Electromagnetic Scattering Response For Discrimination Of Radar Targets With Minor Variations

Electronic Theses of Indian Institute of Science

View Archive Info
 
 
Field Value
 
Title Application Of High Frequency Natural Resonances Extracted From Electromagnetic Scattering Response For Discrimination Of Radar Targets With Minor Variations
 
Creator Menon, K Rajalakshmi
 
Subject Radar Engineering
Radar Target Discrimination
Target Discrimination
Target Identification
Target Recognition
Target Classification
Complex Targets
Canonical Shaped Targets
Cylinder Targets
E-Pulse
Extinction Pulse
Computational Electromagnetic (CPM) Technique
Electromagnetic Scattering Process
Conducting Spheres
Wire Scatterers
Plate Scatterers
Dielectric Coated Spheres
Chiral Coated Spheres
Chirally Coated Spheres
Chiral Sphere
Prony's Method
Aircraft
 
Description Radars, as the name suggests, were traditionally used for Radio Detection and Ranging. Nevertheless, advances in high resolution electromagnetic simulations, Ultra Wide-Band sources, signal processing and computer technologies have resulted in a possible perception of radars as sensors for target discrimination. In this thesis, the feasibility of discrimination between targets even with minor variations in structure and material composition on the basis of radar echoes is effectively demonstrated.

It is well-known that the echoes from any target are affected by its natural frequencies which are dependent only on the shape and material composition of the target, and independent of the aspect angle or the incident waveform. The E-pulse technique is based on the fact that incident waveforms can be designed that uniquely annihilate the echoes from chosen regions of a target, and forms the basis of the method of discrimination proposed in this thesis.

Earlier methods reported in the literature, effectively discriminated only between different classes of targets with substantial variations in the overall dimensions of the body. Discrimination of targets of the same class with a minor structural modification or with a material coating on specific areas was rather difficult. This thesis attempts and successfully validates a method which comprehensively addresses this problem. The key idea of this method is to use the higher frequency resonances (which characterise the finer details of a target) in the E-pulse technique.

An obviously important aspect of target discrimination is therefore that of precisely estimating the natural frequencies for each target and understanding the changes in these frequencies, and their associations with the changes in structure and material composition. Current approaches to determine these frequencies are either based In the time or frequency
domains. While the latter approach comprises the computation of the roots of a related determinantal equation, in the time domain, the natural frequencies are extracted from the
response of a target to an impulse. Such a response can either be generated from actual experiments or by simulating the scattering response using Computational Electromagnetic (CEM) techniques. In this work, the impulse response is obtained from the frequency response of the scatterers in the frequency range of interest. Since no single CEM technique can effectively cover the entire range of frequencies needed for the E-Pulse synthesis. The Method of Moments and Physical Optics have been used for low and high frequency scattering respectively. The results obtained using the latter technique are validated by comparing with those obtained using Method of Moments at the transition frequencies and Geometrical Theory of Diffraction (GTD).

The natural frequencies (i.e., poles of a corresponding transfer function) are extracted from the impulse response using Prony's algorithm. One of the parameters in this method is the number of such poles (i.e.. the order of the transfer function) present in the response, and the accuracy of the computed pole values depends on this assumed order. Here, the Hankel singular values of a transfer function is used to estimate the number of poles. This in turn implies that a specific norm of the error between a transfer function corresponding to the frequency response generated earlier, and a transfer function with an assumed order obtained using Prony's method is minimised.

In the thesis, a wide range of target shapes are considered for purposes of illustration: wires, cylinders, spheres, plates and complex bodies such as aircraft, and the discrimination capability is demonstrated by introducing minor perturbations in their shape and/or material composition. .The following cases are considered here: (a) Wires: Conducting wires with a protrusion in one segment; conducting wire from another coated with a dielectric in a segment, (b) Cylinders: Conducting cylinders with one perturbed; conducting cylinders with a portion scrapped off in the middle, (c) Plates: Conducting plates with a elongation on one comer; conducting plate with another one with a hole in the centre, (d) Spheres: Conducting spheres with different radii; conducting spheres with Radar Absorbing Material coated spheres with different coating thickness; conducting spheres with chiral coated spheres with varying coating thickness, (e) Aircraft: Canonical model of MiG-29 aircraft from a similar one with stores placed under the wing.
 
Publisher Indian Institute of Science
 
Contributor Balakrishnan, N
Ramchand, K
 
Date 2005-10-25T09:15:40Z
2005-10-25T09:15:40Z
2005-10-25T09:15:40Z
2001-04
 
Type Electronic Thesis and Dissertation
 
Format 20744649 bytes
application/pdf
 
Identifier http://hdl.handle.net/2005/159
null
 
Language en
 
Rights I grant Indian Institute of Science the right to archive and to make available my thesis or dissertation in whole or in part in all forms of media, now hereafter known. I retain all proprietary rights, such as patent rights. I also retain the right to use in future works (such as articles or books) all or part of this thesis or dissertation.