Record Details

Resonant Transition Topologies For Push-Pull And Half-Bridge DC-DC Converters

Electronic Theses of Indian Institute of Science

View Archive Info
 
 
Field Value
 
Title Resonant Transition Topologies For Push-Pull And Half-Bridge DC-DC Converters
 
Creator Swaminathan, B
 
Subject Direct Current Machinery
Electric Power Converters
Converters - Analysis and Design
ZVS Push-Pull Converter
Soft Switching Topologies
Switched Mode Power Supplies (SMPS)
Soft Switching
DC-DC Converters
Electrical Engineering
 
Description Switched mode power supplies (SMPS) are being extensively used in most power conversion processes. The analysis, design and modeling processes of hard-switched converters are mature, where the switching frequency was limited to a few 10's of kHz. The present direction of evolution m SMPS is towards higher efficiency and higher power density. These twin objectives demand high switching frequency and low overall losses. Soft switching results in practically zero switching losses and extends the switching frequency to 100's of kHz and beyond.

This thesis presents novel variants of push-pull and half-bridge DC-DC converters with soft switching properties. The proposed topology uses two additional switches and two diodes. The additional switches introduce freewheeling intervals m the circuit and enable loss-less switching. Switch stress, control and small signal model are similar to hard-switched PWM converter. Synchronous rectifiers are used in the ZVS push-pull converter to achieve high efficiency. It is interesting to see that the drives for the synchronous rectifier device are practically the same as the additional switches.

The contributions made in this thesis are
1) Idealized analysis and design methodology for the proposed converters.
2) Validation of the design through circuit simulation as well as prototypes - a 300kHz,
200W push-pull converter and a 300kHz, 640W half-bridge converter.
3) Closed loop control design for desired bandwidth and accuracy Verification of loop
gain through network analyzer instrumental for the same The loop gain bandwidth
achieved is about 30kHz for the push-pull converter and 20kHz for half-bridge
converter.

An appendix has been devoted to explain the use of network analyzer. Characterization of coil, transformer and capacitor are explained in detail. Measurement techniques for measuring the small signal parameters of power supply are also explained in the appendix.
 
Contributor Ramanarayanan, V
 
Date 2007-10-23T10:37:35Z
2007-10-23T10:37:35Z
2007-10-23T10:37:35Z
2004-05
 
Type Thesis
 
Identifier http://etd.iisc.ernet.in/handle/2005/317
 
Language en_US
 
Rights I grant Indian Institute of Science the right to archive and to make available my thesis or dissertation in whole or in part in all forms of media, now hereafter known. I retain all proprietary rights, such as patent rights. I also retain the right to use in future works (such as articles or books) all or part of this thesis or dissertation.